Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
- Brake system
The general information and security measures
Prorolling of brake system and replacement of a brake liquid
Replacement brake колодок
Removal and installation of brake disks
Removal and installation of brake supports
Removal and installation of a pedal of a brake
Removal and installation of the vacuum pump
Removal and installation of the tank of a brake liquid and ГТЦ
Removal and installation of brake lines
Removal and installation of components of a lay brake and its drive
Removal and installation of components of auxiliary systems (ABS/TC/ESP)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement brake колодок
|
|
Replacement brake колодок should be made on both wheels of one axis. The description only for one wheel is more low resulted. |
Lobbies колодки
|
|
Поддомкратьте the car also remove forward wheels.
|
|
Squeeze out the piston of the brake cylinder (2), remove скобу (3) supports, dusterи directing fingers (4) and turn out directing fingers.
|
|
|
Remove a support (5) with анкерной скобы and suspend it on a rack of a suspension bracket so that not to load a brake hose. Remove колодки (6).
|
Clear internal surfaces of a support a soft wire brush and check up a condition dusterов.
Establish new колодки.
|
|
External колодки with the acoustic indicator of deterioration establish the indicator downwards; internal колодки establish so that arrows specified in them in a direction of rotation of a brake disk at car movement forward. |
Establish a support, clear directing fingers and tighten them. Will put on fingers dusterи.
|
|
Establish скобу a support.
|
Establish wheels, lower the car on the earth and squeeze out a brake pedal to wring out pistons of brake cylinders.
In summary check up level of a brake liquid and if necessary modify it.
|
|
Back колодки
Replacement brake колодок back wheels of models since 1999 вып. (With floating back supports) it is made similarly to replacement колодок forward wheels.
|
|
Колодку with a spring it is necessary to establish opposite to the piston. The replacement description колодок models till 1999 вып is more low resulted. (With motionless 2-piston supports). |
|
|
Поддомкратьте the car also remove back wheels.
|
|
Wring out the piston of the brake cylinder (external), take directing fingers and springs (3).
|
Remove колодки. If necessary take advantage of a special stripper.
Clear a soft wire brush of a surface of the support, interfaced with колодками. Examine dusterи and if necessary replace them.
Grease interfaced surfaces колодок with copper greasing and establish колодки in a support.
Establish springs and fingers, then establish wheels and lower the car on the earth.
Squeeze out a brake pedal to wring out pistons of brake cylinders both in summary check up and if necessary modify level of a brake liquid.
|
|
|
|