Saab 9-5

Since 1997 of release

Repair and car operation


Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
- Automatic transmission
   The general information
   Search of malfunctions - the general information
   Removal and installation of assemblage of the lever of the selector of modes АТ and its casing
   Removal, installation and adjustment of a cable of the selector of modes АТ
   Removal and installation of the lever of the selector of modes АТ and dismantling of its casing
   Removal and installation э/м valves AT, their case and its cover
   Removal and installation of gauges of speed
   Removal and installation of hydraulic lines АТ
   Removal and installation TCM
   Replacement and adjustment of the gauge of position of the selector of modes АТ
   Removal and installation АТ
   Replacement of epiploons of power shafts
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal, installation and adjustment of a cable of the selector of modes АТ

Removal and installation

 PERFORMANCE ORDER

    Remove the storage battery together with the pallet.
    Establish АТ in position 1 and remove an arm (2) selectors with АТ, a clip (3) with скобы a cable and a cable (4) with скобы.
    The subsequent removal of a cable is carried out during removal of assemblage of the lever of the selector from its casing (see Has undressed Removal and installation of assemblage of the lever of the selector of modes АТ and its casing). Extend a cable and rubber consolidation in car salon. Installation is made upside-down. For simplification of installation of rubber consolidation grease with its vaseline. In conclusion of installation adjust a selector cable.

Check and adjustment

 PERFORMANCE ORDER

    Adjustment of a cable of the selector of modes АТ is required, if a course of the lever of the selector in positions D and N different.
    Establish the selector lever in position P and lift an adjusting clamp.
    Move the lever on АТ to position P and drive the car before inclusion of blocking of the lever of the selector in position P. Pull the lever on АТ back to choose люфт and, keeping the lever in this position, press an adjustment clamp. Make sure that a course of the lever of the selector identical in positions D and N.